Non-volatile memory Configuration Contactless NFC-F specific options
April 4, 2024 at 3:01 AMNFC-F specific options
Address : 023C (bank 2, register 3C)
Size : 8 bytes
Default : 00FFFF01000B0009
Content
Byte 0 : Options
| Bit | Role | Values |
|---|---|---|
| 7 | RFU | |
| 6 | NFC Forum polling: bail-out after NFC-F response | 0 : Disabled1 : Enabled |
| 5-2 | RFU | |
| 1-0 | Control NFC-F bitrate: 212 and/or 424kbit/s | 0 : Both 212kbit/s and 424bit/s1 : 212 kbit/s only2 : 424 kbit/s only3 : RFU |
Bytes 1-2 : System Code for NFC-F polling
The System Code is a parameter broadcasted by the reader within its NFC-F polling frames.
A card that does not belong to the specified System remains silent (this aims to speed-up the anti-collision loop and avoid the reader to initiate a transaction with “useless” cards).
Remark : Set to FFFF to target all cards (default)
Byte 3 : Request Code for NFC-F polling
Remark : Set to 01 for NFC Forum Type 3 Tag compliance (default)
Bytes 4-5 : Service Code used by READ BINARY with NFC-F cards
For NFC-F cards, the reader’s APDU Interpreter has to translate the ISO/IEC 7816-4 READ BINARY INStruction into a command that is understandable by the target FeliCa card.
The Service Code to be used depends on the card’s application and configuration.
Remark : Set to 000B for NFC Forum Type 3 Tag compliance (default)
Bytes 6-7 : Service Code used by UPDATE BINARY with NFC-F cards
For NFC-F cards, the reader’s APDU Interpreter has to translate the ISO/IEC 7816-4 UPDATE BINARY INStruction into a command that is understandable by the target FeliCa card.
The Service Code to be used depends on the card’s application and configuration.
Remark : Set to 0009 for NFC Forum Type 3 Tag compliance (default)